Seat Concepts KTM SX/XCF ('16) XCW/EXC-F ('17-'19) SX/SXF/XCF/XC ('17-'18) Low Element Complete Seat

The Element seat comes with four traction ribs at the rear to keep you firmly planted in the cockpit comprised entirely of our gripper material.

Secondly, each Element seat comes seam sealed from the inside to prevent water from penetrating into the foam. We don't stop there, before the cover is installed each foam is covered with a thin water barrier as added protection from the elements.
Rain...Snow...Mud or anywhere in between the Element seat is a must have for year-round use.

Seat Concepts seats are constructed using a foam material that is a much higher quality than OEM seat foam. Their proprietary formula provides a more plush and active ride, while still offering the necessary amount of support. Their unique comfort shape maintains a similar contour to stock at the front of the seat so the rider’s legs are not spread farther apart, but tapers out towards the mid-point to distribute rider weight over a greater area.

These features combine to offer a custom seat feel, and provide greater enjoyment and increased range on a long commute, or Dual-Sport ride!

• Width: 197mm (7 3/4")
• Height: 17mm (5/8") Lower than stock

Note:
Some 2016 models did not have an indentation in the underside of the seat pan called a pan pocket that provides additional clearance for an electrical module that will be present on TPI models. Our LOW foam and cover kit only works on models WITHOUT the pan pocket. Verify if your stock pan has a pocket if ordering a kit. Our Standard height and Tall models are available as a foam and cover kit, for models with or without a pan Pocket. All standard and tall Seat Concepts 2016-18 KTM Complete seats have pan pockets. Our low seat will NOT work on the TPI models.

THIS LOW SEAT WILL NOT FIT THE 2 STROKE FUEL INJECTED MODELS

Important Information:
The Complete Seats come assembled with an aftermarket pan and ready to ride.

Per OEM specifications, the seat bolts should be tightened NO MORE than 7 ft/lbs to prevent tightening or stripping. Over tightening can cause a failure. Cross threading can also be an issue and should be avoided. DO NOT use air tools to tighten seat bolts as it can cause them to be stripped.

• Black/Black/Orange (out of stock)
• Blue/Blue/Orange (out of stock)

• Complete Seat (out of stock)