IMS Products Yamaha WR250R 18 Litre Fuel Tank

IMS Products is proud to announce its new Adventure Tank for the Yamaha WR250R/X. We call this an Adventure tank because it maximizes your capacity preparing you for those extended trips without the need to stop and fill up. This tank has a 10 Litre advantage over the stock fuel tank and it handles it well.

We made this Adventure tank to replace the stock radiator shrouds and keep the fuel down low for a lower center of gravity, improving the handling and stability of the bike. We also have installed a lift pump to allow the stock fuel pump to stay in the standard position while efficiently utilizing the entire capacity of the tank.

Capacity: 17.8 Litres

Colours: Translucent

Fits: WR250R, 2008 - current model years

Includes: Fuel cap with breather hose

Decals not included

h3>Parts List

• (1) Fuel Tank
• (1) Gas Cap & Seal
• (1) 5/32 Vent hose 24” long
• (1) 5/32 Vacuum line 10” long
• (1) 5/32 vacuum Tee fitting
• (2) Ty-raps
• (1) VITON O-Ring DASH # 413 0.25 x 2.975 x 3.5 in

Stock Items To Use

• Fuel pump
• Mounting hardware
• Seat Hook Fixture

Tank Removal Instructions

Drain the fuel from stock tank into an approved gasoline container. Remove the seat and shrouds unbolt the tank and raise the tank up enough to disconnect the fuel line and power cable. California models have a vapor hose on the left side to disconnect (more on this below), remove tank from the frame.

Notice: REPLACE THE OEM “V” SEAL ON THE PUMP WITH THE O-RING PROVIDED BEFORE RE-INSTALLING.

Fuel Tank Installation Instructions

On California models remove the short vapor hose from the plastic Roll over valve and connect the new vent hose. Route the hose so you can connect it to the new gas cap once the tank is installed.

Set both fuel tanks on their back, side by side to each other and note the location of the fuel spigot on the pump. Remove the pump and replace the “V” seal with the large O-Ring provided with the tank. Transfer the pump into the IMS tank with the spigot in the same position; it will only mount one way. Now transfer the front and back mounting brackets onto the IMS tank.

Set the IMS tank onto the bike and reattach the fuel line & power cable. Bolt the tank to the frame using the stock hardware. Attach the two shroud brackets to the IMS tank with the (4) 6-32 screws with the mounting holes to the back. Attach the shrouds using the stock hardware. Transfer the seat hook to the IMS tank & replace the seat. Connect the new vent/vapor line to the IMS gas cap. N

on-California models route vent line from the gas cap and into the steering stem.

• Blue (out of stock)
• Clear
• Black
• White